Braindump2go 300-101 Dumps,300-101 Exam Questions,300-101 PDF Dumps,300-101 VCE Dumps,Cisco [Updated 300-101 Dumps]Valid Braindump2go 300-101 VCE Dumps 739Q Offer[Q655-Q665]

[Updated 300-101 Dumps]Valid Braindump2go 300-101 VCE Dumps 739Q Offer[Q655-Q665]

2018/10/22 Braindump2go 300-101 Exam Dumps with PDF and VCE New Updated Today! Following are some new 300-101 Real Exam Questions:

1.|2018 Latest 300-101 Exam Dumps (PDF & VCE) 739Q&As Download:

https://www.braindump2go.com/300-101.html

2.|2018 Latest 300-101 Exam Questions & Answers Download:

https://drive.google.com/drive/folders/0B75b5xYLjSSNUlpIeEc2YV9vRDg?usp=sharing

QUESTION 655
Which option is the best for protecting CPU utilization on a device?

A. fragmentation
B. COPP
C. ICMP redirects
D. ICMP unreachable messages

Answer: B

QUESTION 656
Which NAT command do you enter to disable dynamic ARP learning on an interface?

A. R1(config-if)#ip nat enable
B. R1(config-if)#ip nat inside
C. R1(config)#ip nat serive
D. R1(config-if)#ip nat outside
E. R1(config)#ip nat allows-static-host

Answer: E

QUESTION 657
Which two statements about EVN are true?

A. It supports IPv6 traffic.
B. It can support up to 16 VNs.
C. It uses redistribution to share routes between VNs.
D. It supports SSM only.
E. A configuration can be based on an existing VRF configuration

Answer: CE

QUESTION 658
What does stateful NAT64 do that stateless NAT64 does not do?

A. Stateful NOT64 maintains bindings of IPv4 to IPv6 link-local addresses.
B. Stateful NAT64 translates IPv4 to IPv6.
C. Stateful NAT64 translates IPv6 to IPv4.
D. Stateful NAT64 maintains bindings or session state while performing translation.

Answer: D

QUESTION 659
What are two impotant differences between OSPFv2 and OSPFv3 (Choouse two.)

A. Only OSPFv3 provides support for IPv6.
B. Only OSPFv3 automatically chooses a router ID for the local device.
C. Only OSPFv3 supports multiple OSPF instances on a single link.
D. Only OSPFv3 automatically enable interfaces when you create them in device configuration mode.
E. Only OSPFv3 automatically detects OSPF neighbors on an NBMA interface.

Answer: AC

QUESTION 660
Which adverse event can occur as a consequence of asymmetric routing on the network?

A. vulnerability to a man-in the – middle atack
B. inadventent HSRP active router preemption
C. errdisabled port
D. unicast flooding

Answer: D

QUESTION 661
Which feature can automatically assign IP addresses in a PPPoE environment?

A. DHCP
B. BOOTP
C. PPP
D. APPA

Answer: C

QUESTION 662
Refer to the exhibit. How does R1 handle the route to netowk 10.1.80.0.0/24?

A. R1 redistributes network 10.1.80.0/24 into EIGRP without changing the mask
B. R1 changes the mask to /32 and then redistributes network 10.1.80.0/24 into EIGRP as a classful network
C. R1 changes the mask to /32 and then redistributes network 10.1.80.0/24 into EIGRP as a classless network
D. R1 fails to redistribute network 10.1.80.0/24 into EIGRP

Answer: A

QUESTION 663
Which STP feature can reduce TCNs on ports that are connected to end devices?

A. BPDU guard
B. Root guard
C. PortFast
D. BackboneFast

Answer: C

QUESTION 664
Which command must you configure globally to support RIPng?

A. ip routing
B. ip cef
C. ipv6 enable
D. ipv6 unicast-routing

Answer: D

QUESTION 665
Which protocol does VRF-Lite support?

A. IS-IS
B. ODR
C. EIGRP
D. IGRP

Answer: C


!!!RECOMMEND!!!

1.|2018 Latest 300-101 Exam Dumps (PDF & VCE) 739Q&As Download:

https://www.braindump2go.com/300-101.html

2.|2018 Latest 300-101 Study Guide Video:

https://youtu.be/6lHfKlW8bNY

Related Post